13024173 is recorded as a cylinder liner for an XCMG loader engine application. A liner is matched to both the engine block and piston/ring group. The rebuild result depends on verified dimensions, the block seat and installed liner height—not simply on sliding a new sleeve into place.
Confirm the Liner Configuration
| Part number | 13024173 |
|---|
| Product type | Engine cylinder liner |
|---|
| Application | XCMG loader engine; confirm exact engine configuration |
|---|
| Critical checks | Engine serial, liner type, bore, outside diameters, length, flange or shoulder, lower end and seal grooves |
|---|
Send the engine plate and photos of the old liner from the top, side and lower end. Identify whether measurements are taken from an unworn reference area. A worn bore or eroded outside surface should not be the only specification.
Inspect the Block Before Ordering
Clean the liner seat and block bore so corrosion, carbon or seal residue does not hide damage. Check the counterbore or seating surface, lower support and any sealing area. Erosion, fretting or an uneven seat can prevent correct liner height and sealing. If coolant entered the crankcase, confirm the leakage path rather than assuming the liner is the only cause.
This page does not state whether 13024173 is a wet or dry liner, nor does it publish unsupported bore, interference or protrusion values. Verify these from engine service data.
Measure as a Complete Cylinder Group
Confirm liner bore and outside profile.
Match piston diameter, pin arrangement and ring pack to the same engine.
Inspect connecting rod, piston cooling parts and head sealing face.
Measure installed liner height at specified positions and clamping condition.
Check every cylinder falls within permitted variation.
Confirm whether liner seals, shims or installation parts are included.
Clean Assembly and Commissioning
Use correct tools so the block and liner are not scored. Clean oil and coolant passages, follow the specified seal lubricant and orientation, and avoid striking the liner flange. Apply the correct head-gasket and tightening procedure. Refill specified fluids and monitor leakage, temperature, pressure and crankcase condition during controlled initial operation.
Related XCMG Loader Engine Parts
An overhaul may also involve the TD226 cylinder head, the WD615.67/68 repair kit and the water pump 612600060131. These links are overhaul references and do not confirm compatibility with liner 13024173.
Frequently Asked Questions
Does 13024173 confirm the engine model?
It is the liner reference, but provide the exact engine model and serial.
Is the liner wet or dry?
The source record does not verify the type. Compare the outside profile, seal grooves and engine documentation.
Are seals included?
No supply scope is stated. Request an itemized quotation for liner, seals, shims and companion parts.
Why is liner protrusion important?
Installed height affects head sealing and load distribution. Measure it only by the applicable engine procedure.
Quotation checklist: send 13024173, engine plate and serial, old liner photos, dimensions, flange and lower-end details, quantity and seal scope.
