EPEC 2024 Operator Control Panel with MC2M Module: Application and Matching Guide
This operator-panel assembly combines physical controls with EPEC/MC2M electronics, so switch layout and programmed functions must match the crane.
For a faster quotation: send epec 2024 and mc2m module identification, switch, joystick and indicator layout, rear harness connectors and pinout, together with the machine model and installation photo.
Panel Layout, MC2M Module and CAN-System Verification
EPEC 2024 and MC2M module identification
switch, joystick and indicator layout
rear harness connectors and pinout
CAN network and machine software version
Where This Part Is Used
Installed in compatible XCMG crane operator stations to transmit commands and display control status over the machine network.
Failure Clues and Workshop Check
Dead switches, missing CAN messages or incorrect functions may be caused by the panel, module, supply, harness or programming. Scan the network before replacement.
Installation and Handover
Photograph connector positions, isolate power, protect modules from static, confirm CAN termination and test every command plus safety interlock after programming.
Related Parts and Technical Reference
See EPEC 2024 crane controller when checking the surrounding system. The highlighted link helps buyers compare related components without leaving the parts catalogue.
Buyer FAQ
What must be confirmed before ordering this EPEC control panel?
Confirm epec 2024 and mc2m module identification; switch, joystick and indicator layout; rear harness connectors and pinout; can network and machine software version.
Can only the MC2M module be replaced?
Possibly, but hardware code, program and the fault location must be confirmed first.
Export Packing
Switches and display surfaces are guarded, electronics are anti-static wrapped, and the panel is supported in a rigid crate.
