XCMG Crane Cable Connector Set: Application and Matching Guide
A matched connector set restores a reliable electrical joint in the crane harness; correct terminals and seals are as important as the housing.
For a faster quotation: send male and female housing profiles, pin count, cavity numbering and keying, terminal family and supported wire gauge, together with the machine model and installation photo.
Housing, Pin Count, Terminals and Seal Compatibility
male and female housing profiles
pin count, cavity numbering and keying
terminal family and supported wire gauge
individual seals and secondary locks
Where This Part Is Used
Used to repair compatible XCMG crane sensor, valve, lighting or controller harness connections.
Failure Clues and Workshop Check
Water ingress, green corrosion, loose pins or heat damage require inspection of wire strands, current load and mating-component pins.
Installation and Handover
Crimp with the specified tool, pull-test each terminal, insert by cavity number, fit seals and locks, then check continuity and insulation.
Related Parts and Technical Reference
See XCMG QY-series CAN communication board when checking the surrounding system. The highlighted link helps buyers compare related components without leaving the parts catalogue.
Buyer FAQ
What must be confirmed before ordering this cable connector set?
Confirm male and female housing profiles; pin count, cavity numbering and keying; terminal family and supported wire gauge; individual seals and secondary locks.
Can old terminals be transferred into a new housing?
Only undamaged terminals with correct locking tangs and seals should be reused; replacement is usually safer.
Export Packing
Small terminals, seals and housings are compartmented and labeled to prevent loss or cavity contamination.
