XCMG Crane Driver-Cab Ignition Switch: Application and Matching Guide
The ignition switch distributes battery, accessory, run and start power in the crane carrier cab; terminal logic must match the harness.
For a faster quotation: send off-acc-on-start position sequence, rear terminal labels and connector, 12 v or 24 v circuit and current rating, together with the machine model and installation photo.
Key Positions, Terminals and Starter-Circuit Matching
OFF-ACC-ON-START position sequence
rear terminal labels and connector
12 V or 24 V circuit and current rating
barrel diameter, key and mounting nut
Where This Part Is Used
Installed in selected XCMG truck-crane driver dashboards to control carrier electrical and engine-start circuits.
Failure Clues and Workshop Check
Intermittent crank, hot terminals or loss of accessory power can come from switch contacts, connector tension, relay circuits or battery voltage.
Installation and Handover
Disconnect the battery, label terminals, compare continuity by key position and verify starter relay operation without overheating the switch.
Related Parts and Technical Reference
See DK2312A battery disconnect switch when checking the surrounding system. The highlighted link helps buyers compare related components without leaving the parts catalogue.
Buyer FAQ
What must be confirmed before ordering this ignition switch?
Confirm off-acc-on-start position sequence; rear terminal labels and connector; 12 v or 24 v circuit and current rating; barrel diameter, key and mounting nut.
Can terminals be matched only by location?
No. Use terminal markings or a wiring diagram because layouts can look similar but switch differently.
Export Packing
Keys are secured separately, the barrel is cushioned and electrical terminals are protected from bending and moisture.
