XCMG Crane Engine Oil Pressure Gauge: Application and Matching Guide
This dashboard instrument shows engine lubrication pressure to the crane carrier operator. The gauge and sender must use the same signal curve for an accurate reading.
For a faster quotation: send front and rear photos, scale units, bezel diameter, terminal labels, system voltage and sender number.
Gauge Scale, Sender Curve and Dashboard Fitment
Display scale and pressure units
12 V or 24 V electrical system
Sender resistance or signal compatibility
Bezel diameter, mounting clamp and terminal layout
Where This Part Is Used
Installed in selected XCMG crane carrier instrument panels for continuous engine oil-pressure monitoring.
Failure Clues and Workshop Check
No movement, full-scale reading, unstable indication or failed backlight can originate in the gauge, sender, ground or harness. Test the circuit before replacing both components.
Installation and Handover
Disconnect power, label every terminal, secure the mounting clamp without distorting the panel and validate the reading against known pressure or a test sender.
Related Parts and Technical Reference
See XCMG crane engine oil-pressure sensor when checking the surrounding system. The highlighted link helps buyers compare related components without leaving the parts catalogue.
Buyer FAQ
Will any 24 V oil-pressure gauge work?
No. The sender curve, scale and terminal arrangement must also match.
Should the gauge and sender be replaced together?
Only after testing; replace the failed component unless the matched pair is obsolete or incompatible.
Export Packing
The lens, bezel and terminals are cushioned separately, with moisture protection for the instrument movement.
