45 m PAT Cable for XCMG Crane LMI System: Application and Matching Guide
This 45 m cable carries PAT/LMI sensor signals along the crane boom. Its connector keying, shielding and routing affect reliable length or angle feedback.
For a faster quotation: send clear photos of both connectors, pin count, cable markings, required route length and LMI/PAT model.
Connector, Pinout, Shielding and 45 m Length Checks
Overall cable length: 45 m reference
Connector shells, keying, pin count and pinout
Shielding, outer-jacket diameter and reel interface
PAT/LMI system and sensor model
Where This Part Is Used
Used between compatible PAT sensors, cable reels and load-moment computers on XCMG cranes with long boom routing.
Failure Clues and Workshop Check
Intermittent length readings, implausible angle values or communication alarms can come from broken conductors, damaged shielding, water ingress or connector tension.
Installation and Handover
Route away from pinch points and hot surfaces, preserve the designed bend radius, secure strain relief and verify continuity plus insulation before calibration.
Related Parts and Technical Reference
See Hirschmann IC3600 crane display when checking the surrounding system. The highlighted link helps buyers compare related components without leaving the parts catalogue.
Buyer FAQ
Is cable length the only selection criterion?
No. Connector family, pinout, shielding and system generation must match as well.
Can a damaged LMI cable be spliced?
A temporary repair may change shielding or resistance; a correctly specified complete cable is preferred for a safety-related system.
Export Packing
Connectors are capped and cushioned, while the cable is coiled above its minimum bend radius and moisture-protected.
