Front Headlight AZ9100720011 for XCMG Cranes
AZ9100720011 is a front headlight reference used on compatible XCMG K-series crane carriers, including selected QY25K and QY70K configurations. Housing side, connector, voltage and beam pattern must match.
Identification and Matching
Part number AZ9100720011
Left/right installation position
Carrier voltage and bulb/light source
Connector and pin arrangement
Housing mounts and beam pattern
Application and Service Scenarios
Use after broken lens or housing, water entry, damaged reflector or confirmed internal electrical failure. Bulbs, fuses, relays, grounds and harness connectors should be tested before replacement.
Inspection and Installation
Disconnect power, compare the mounting and connector, seal against water and route wiring safely. Aim the beam using the applicable road and service requirements and verify low/high beam functions.
Frequently Asked Questions
Does this fit both sides?
Confirm the side and housing orientation before ordering.
Does a dark lamp mean the assembly failed?
No. Check bulb, fuse, relay, power and ground.
Is beam aiming necessary?
Yes, after headlight replacement.
Export Packing
The lens is surface-protected and the housing is cushioned against vibration and impact.
