XCMG XCT Accelerator Pedal 803611230
XCMG 803611230 is an accelerator pedal assembly for compatible XCT crane carriers. The pedal converts operator input into an electronic demand signal, so connector, signal tracks and mechanical mounting must match.
Identification and Matching
XCMG part 803611230
Carrier and engine-control configuration
Connector keying and pin count
Pedal bracket and mounting holes
Idle and full-travel signal requirements
Application and Service Scenarios
Evaluate after dead spots, unstable engine response, implausible pedal faults, damaged return mechanism or confirmed signal-track failure. Wiring, supply voltage, grounds and engine ECU inputs must also be tested.
Inspection and Installation
Disconnect power, inspect the floor bracket and harness, then mount without restricting pedal travel. Use diagnostics to verify both signal tracks, idle value, smooth travel and full return.
Frequently Asked Questions
Can a similar electronic pedal be used?
Only when connector, signal and mounting specifications match.
Does poor acceleration prove pedal failure?
No. Check engine faults, wiring and ECU data.
Is calibration needed?
Follow the exact carrier and engine service procedure.
Export Packing
The pedal arm is immobilized and connector and sensor housing are protected from impact and moisture.
