Confirm the Euro II assembly, not just the crane model
This listing identifies an electrical swivel for the XCMG QY16K.70.7B Euro II configuration. Swivel assemblies can differ by build and circuit arrangement, so the QY16K name alone is not enough to establish fit. Compare the stamped code, machine serial plate and installed unit before requesting a replacement.
What helps confirm the match
Photograph the QY16K.70.7B code and full crane data plate.
Show the installed swivel, mounting orientation and all connectors.
Record wire count, pin positions and the circuits each track serves.
Compare mating dimensions and any revision markings with the removed assembly.
A fault in one indication does not automatically prove the swivel has failed. Check power, ground, harness continuity and the connected module first; an open wire or loose terminal can produce similar symptoms.
Replacement and return-to-service checks
Isolate power before disconnection and label each circuit. Protect the contact surfaces from dirt, then verify continuity and each affected function after installation. Keep the removed part and its label available until the new unit has passed the machine-specific check.
For comparison only, see the XCMG Euro III electrical swivel; Euro II and Euro III assemblies should not be treated as interchangeable without code-level confirmation.
Buyer questions
Does every QY16K use this swivel?
No. Confirm QY16K.70.7B, Euro II configuration, serial range and the code on the fitted assembly.
What photos should I send?
Send the data plate, part label, connector faces and a wider installation view.
Can I test only the replacement swivel on the bench?
Continuity checks can help, but final verification must include the connected circuits and crane functions.
Export handling: Keep contacts protected, preserve identification and secure the assembly against movement in transit.