This product record lists a bulldozer seal ring, part number 16Y-15-00017. The page does not identify its dimensions, material or the medium being sealed. Confirm the ring’s position in the machine parts catalogue and use the full reference when requesting a replacement.
Why the assembly location matters
A seal ring is selected for a specific groove and interface. Two rings can look similar while differing in section, material or compression requirements. Check the machine make, model and serial, then confirm 16Y-15-00017 in the correct catalogue revision. If the equipment has a repaired or modified assembly, provide the details rather than assuming the standard configuration.
Before putting the joint back together
Inspect the groove for wear and contamination, clean the mating surfaces carefully and follow the service manual for installation orientation. Avoid twisting the ring or using unapproved sealant. Verify the joint with the equipment’s specified leak check after assembly. If the original seal failed, inspect the adjoining parts and operating conditions as directed by the manual.
Other distinct references in the same category include 16Y-15-00079 and 16Y-15-00080; choose by exact number and catalogue position, not by the shared “seal ring” name.
Buyer FAQ
What does this seal ring fit?
The exact assembly is not stated here. Confirm using the machine serial and diagram.
Can you infer dimensions from the part number?
No. Request verified dimensions from the supplier or parts documentation.
Can a nearby reference work instead?
Only if the manufacturer’s catalogue confirms it for the same application.
