The right-hand bit end 16Y-81-00003 is listed for Shantui SD13, SD16, SD22, SD23 and SD32 bulldozers. Confirm the machine serial and the operator-facing left/right orientation before ordering. The “R.H.” designation matters; the matching part for the opposite side has a different number.
Check the blade position and fastener pattern
Compare 16Y-81-00003 with the machine parts diagram and the existing end bit. Confirm the side, hole spacing and mating edge before purchase. If the blade has been modified or uses a replacement moldboard, send photos and measurements to the supplier for confirmation. The listed model range is a starting point, not a substitute for a serial-based check.
Replace as part of an edge inspection
Inspect the adjacent cutting edge and fasteners for wear or damage. Follow the service instructions for safe support, bolt removal and tightening. Replace worn hardware where required by the manual and check that the bit seats flush against its mating surface. Recheck the assembly after the prescribed initial use period.
The opposite-side listing is left-hand bit end 16Y-81-00002. The side and part number differ, so use the correct one for the operator-facing position.
Buyer FAQ
Which machines are listed?
Shantui SD13, SD16, SD22, SD23 and SD32 are listed. Verify the serial.
Is this the left or right part?
It is the right-hand bit end. Confirm orientation from the operator’s position and parts diagram.
Are bolts included?
The listing does not specify package contents. Ask the supplier to confirm.
