Shantui 175-27-31510 Final Drive Seat / Bracket

Part 175-27-31510 is used in a compatible Shantui bulldozer final-drive group. Catalogue naming can vary between “seat” and “bracket,” so the exploded-diagram position and machined interfaces should be checked before purchase.

Fast identification: send the bulldozer model and serial number, parts-book screenshot, casting marks, mounting-hole centers and photos of the removed part beside a ruler.

Fitment Details to Compare

• Part reference 175-27-31510, including any suffix

• Mounting-hole number, diameter and center spacing

• Machined bore, shoulder and contact-face dimensions

• Final-drive housing position and adjoining components

Inspection Before Assembly

Check for cracks around bolt holes, fretting on the seating face, distorted threads and uneven contact marks. Damage in a bearing, shaft or housing can transfer abnormal load to the new bracket.

Installation and Handover

Clean every mating surface, verify dowels or locating shoulders, use the specified fasteners and tightening sequence, and confirm that the assembled final drive turns freely with the correct end clearance.

Ordering FAQ

Is 175-27-31510V1 the same part?

Do not assume interchangeability. Send the complete original number and parts-book position because suffixes can identify a revised component.

Why are measurements needed when the number is visible?

Older machines may have revised final-drive groups, so dimensions provide a second check against an incorrect catalogue selection.

Export Packing

Machined faces and bores are rust protected and covered; the casting is immobilized in a reinforced export carton or crate.