This bulldozer-parts listing identifies a shaft coupling as 16Y-15-00009. The record does not provide dimensions or name the connected assemblies, so confirm the coupling’s exact position from the machine’s parts diagram. A coupling must match the shaft interface and assembly details; a similar outside diameter is not enough.
Prepare a useful identification request
Include the full part number, machine model and serial, and a photo of the installed coupling and its connection faces. Ask the supplier to confirm the catalogue application and whether any keys, fasteners or companion pieces are included. Keep the number exact, including each digit, when comparing against another coupling reference.
Check mating parts during service
Inspect connected shafts for wear, damage or misalignment and review the service procedure for assembly orientation and fastener requirements. If the coupling failed, assess the surrounding drive components instead of treating the replacement as the only corrective action. Follow the machine manufacturer’s method for installation and post-service checks; do not assume interchangeability from similar wording.
A separate coupling is listed as 16Y-11-10000. The two references are distinct; compare the correct diagram position rather than choosing by name alone.
Frequently asked questions
Are 16Y-15-00009 and 16Y-11-10000 interchangeable?
No interchangeability is stated. They are separate references; verify the machine catalogue position.
What dimensions are available?
None are supplied in this record. Request verified dimensions if required.
What should be checked after a coupling failure?
Inspect mating shafts and alignment and follow the machine’s service procedure.
