Motor Grader Air Conditioner Assembly – Voltage, Mounting and Hose Guide
This cab air-conditioning assembly must be matched to the exact motor grader system. Define whether the item is a complete HVAC system, rooftop unit, evaporator or another subassembly before quotation. Similar-looking parts can use different internal or mounting details.
Ordering basis: Confirm system voltage, compressor and evaporator configuration, refrigerant circuit, hose fittings, mounts and cab interfaces before ordering.
Information buyers should provide
Machine model, serial number and installed location.
All casting, stamped or label numbers.
Clear photographs of every connection and mounting face.
Measurements for system voltage, compressor and evaporator configuration, refrigerant circuit, hose fittings, mounts and cab interfaces.
Diagnose the surrounding system
Inspect the mating components, fluid or mechanical condition and the original failure pattern. Define whether the item is a complete HVAC system, rooftop unit, evaporator or another subassembly before quotation. Replacing the part without correcting contamination, misalignment or adjustment faults can cause repeat damage.
Installation and functional verification
Keep interfaces clean, compare the old and replacement parts side by side and follow the machine service procedure. After installation, check leakage, free movement, noise, temperature and the related machine function under controlled conditions.
Product record
| Component | Cab air-conditioning assembly |
| Part number | Not shown — verify from the original component or parts catalogue |
| Fitment rule | system voltage, compressor and evaporator configuration, refrigerant circuit, hose fittings, mounts and cab interfaces |
Related product reference
Review the motor grader driver-cabin guide for another component-level identification workflow. The linked product is a reference only and does not establish interchangeability.
FAQ
Can this cab air-conditioning assembly be matched from a photograph?
A photograph helps, but system voltage, compressor and evaporator configuration, refrigerant circuit, hose fittings, mounts and cab interfaces must also be verified.
What should be inspected before installation?
Check mating parts, mounting faces, lines or fasteners and the cause of the original failure.
Why are unverified model claims avoided?
The original record does not contain enough evidence to prove a specific model fitment.
Compatibility note: Final selection requires system voltage, compressor and evaporator configuration, refrigerant circuit, hose fittings, mounts and cab interfaces.
