Motor Grader Brake Shoe Assembly – Size, Lining and Hardware Guide
This brake shoe assembly must be matched to the exact motor grader system. Assembly scope must state whether springs, pins, adjusters and retainers are included. Similar-looking parts can use different internal or mounting details.
Ordering basis: Confirm drum diameter, shoe width, anchor and spring arrangement, lining profile and axle position before ordering.
Information buyers should provide
Machine model, serial number and installed location.
All casting, stamped or label numbers.
Clear photographs of every connection and mounting face.
Measurements for drum diameter, shoe width, anchor and spring arrangement, lining profile and axle position.
Diagnose the surrounding system
Inspect the mating components, fluid or mechanical condition and the original failure pattern. Assembly scope must state whether springs, pins, adjusters and retainers are included. Replacing the part without correcting contamination, misalignment or adjustment faults can cause repeat damage.
Installation and functional verification
Keep interfaces clean, compare the old and replacement parts side by side and follow the machine service procedure. After installation, check leakage, free movement, noise, temperature and the related machine function under controlled conditions.
Product record
| Component | Brake shoe assembly |
| Part number | Not shown — verify from the original component or parts catalogue |
| Fitment rule | drum diameter, shoe width, anchor and spring arrangement, lining profile and axle position |
Related product reference
Review the motor grader foot-brake valve guide for another component-level identification workflow. The linked product is a reference only and does not establish interchangeability.
FAQ
Can this brake shoe assembly be matched from a photograph?
A photograph helps, but drum diameter, shoe width, anchor and spring arrangement, lining profile and axle position must also be verified.
What should be inspected before installation?
Check mating parts, mounting faces, lines or fasteners and the cause of the original failure.
Why are unverified model claims avoided?
The original record does not contain enough evidence to prove a specific model fitment.
Compatibility note: Final selection requires drum diameter, shoe width, anchor and spring arrangement, lining profile and axle position.
