Motor Grader Connecting Flange 85861013 – Pilot and Bolt Guide
This connecting flange 85861013 must be matched to the exact motor grader system. The recorded part number is useful, but flange geometry and mating equipment still need confirmation. Similar-looking parts can use different internal or mounting details.
Ordering basis: Confirm part number 85861013, pilot diameter, bolt circle, thickness, offset and mating shafts before ordering.
Information buyers should provide
Machine model, serial number and installed location.
All casting, stamped or label numbers.
Clear photographs of every connection and mounting face.
Measurements for part number 85861013, pilot diameter, bolt circle, thickness, offset and mating shafts.
Diagnose the surrounding system
Inspect the mating components, fluid or mechanical condition and the original failure pattern. The recorded part number is useful, but flange geometry and mating equipment still need confirmation. Replacing the part without correcting contamination, misalignment or adjustment faults can cause repeat damage.
Installation and functional verification
Keep interfaces clean, compare the old and replacement parts side by side and follow the machine service procedure. After installation, check leakage, free movement, noise, temperature and the related machine function under controlled conditions.
Product record
| Component | Connecting flange 85861013 |
| Part number | 85861013 |
| Fitment rule | part number 85861013, pilot diameter, bolt circle, thickness, offset and mating shafts |
Related product reference
Review the motor grader drive-shaft flange guide for another component-level identification workflow. The linked product is a reference only and does not establish interchangeability.
FAQ
Can this connecting flange 85861013 be matched from a photograph?
A photograph helps, but part number 85861013, pilot diameter, bolt circle, thickness, offset and mating shafts must also be verified.
What should be inspected before installation?
Check mating parts, mounting faces, lines or fasteners and the cause of the original failure.
Why are unverified model claims avoided?
The original record does not contain enough evidence to prove a specific model fitment.
Compatibility note: Final selection requires part number 85861013, pilot diameter, bolt circle, thickness, offset and mating shafts.
