Motor Grader Connecting Plate 85763001 – Hole and Offset Guide
This connecting plate 85763001 must be matched to the exact motor grader system. The plate must align connected components without forced assembly or unintended preload. Similar-looking parts can use different internal or mounting details.
Ordering basis: Confirm part number 85763001, hole diameters, centre spacing, thickness, offset and mounting orientation before ordering.
Information buyers should provide
Machine model, serial number and installed location.
All casting, stamped or label numbers.
Clear photographs of every connection and mounting face.
Measurements for part number 85763001, hole diameters, centre spacing, thickness, offset and mounting orientation.
Diagnose the surrounding system
Inspect the mating components, fluid or mechanical condition and the original failure pattern. The plate must align connected components without forced assembly or unintended preload. Replacing the part without correcting contamination, misalignment or adjustment faults can cause repeat damage.
Installation and functional verification
Keep interfaces clean, compare the old and replacement parts side by side and follow the machine service procedure. After installation, check leakage, free movement, noise, temperature and the related machine function under controlled conditions.
Product record
| Component | Connecting plate 85763001 |
| Part number | 85763001 |
| Fitment rule | part number 85763001, hole diameters, centre spacing, thickness, offset and mounting orientation |
Related product reference
Review the motor grader component fitment guide for another component-level identification workflow. The linked product is a reference only and does not establish interchangeability.
FAQ
Can this connecting plate 85763001 be matched from a photograph?
A photograph helps, but part number 85763001, hole diameters, centre spacing, thickness, offset and mounting orientation must also be verified.
What should be inspected before installation?
Check mating parts, mounting faces, lines or fasteners and the cause of the original failure.
Why are unverified model claims avoided?
The original record does not contain enough evidence to prove a specific model fitment.
Compatibility note: Final selection requires part number 85763001, hole diameters, centre spacing, thickness, offset and mounting orientation.
