Motor Grader Brake Shoe – Radius, Width and Lining Guide
This individual brake shoe must be matched to the exact motor grader system. An individual shoe must match its drum and opposite shoe; brake parts should be evaluated as a balanced set. Similar-looking parts can use different internal or mounting details.
Ordering basis: Confirm drum diameter, shoe radius, width, pivot geometry, lining thickness and wheel position before ordering.
Information buyers should provide
Machine model, serial number and installed location.
All casting, stamped or label numbers.
Clear photographs of every connection and mounting face.
Measurements for drum diameter, shoe radius, width, pivot geometry, lining thickness and wheel position.
Diagnose the surrounding system
Inspect the mating components, fluid or mechanical condition and the original failure pattern. An individual shoe must match its drum and opposite shoe; brake parts should be evaluated as a balanced set. Replacing the part without correcting contamination, misalignment or adjustment faults can cause repeat damage.
Installation and functional verification
Keep interfaces clean, compare the old and replacement parts side by side and follow the machine service procedure. After installation, check leakage, free movement, noise, temperature and the related machine function under controlled conditions.
Product record
| Component | Individual brake shoe |
| Part number | Not shown — verify from the original component or parts catalogue |
| Fitment rule | drum diameter, shoe radius, width, pivot geometry, lining thickness and wheel position |
Related product reference
Review the motor grader brake-system guide for another component-level identification workflow. The linked product is a reference only and does not establish interchangeability.
FAQ
Can this individual brake shoe be matched from a photograph?
A photograph helps, but drum diameter, shoe radius, width, pivot geometry, lining thickness and wheel position must also be verified.
What should be inspected before installation?
Check mating parts, mounting faces, lines or fasteners and the cause of the original failure.
Why are unverified model claims avoided?
The original record does not contain enough evidence to prove a specific model fitment.
Compatibility note: Final selection requires drum diameter, shoe radius, width, pivot geometry, lining thickness and wheel position.
