154-15-41130 is the normalized part-number entry for this bulldozer seal-ring listing; the source record contained trailing whitespace, which has been removed from the field. The product name alone does not reveal the sealing medium, dimensions or assembly position, so verify the number in the machine’s parts catalogue before ordering.

Make the serial-number check

Provide the machine manufacturer, model and serial, and locate 154-15-41130 in the applicable diagram. Confirm the groove and mating component from the drawing. If a supplier quote or old package shows a suffix or revision, share it before purchase so the reference can be reconciled. Do not treat a similar seal in another catalogue family as a direct substitute.

Installation and service context

Inspect the groove and contact surfaces for wear or damage, clean them carefully, and install the ring using the method specified for that assembly. A ring that is twisted, pinched or installed in a damaged groove may not seal correctly. Use only the service-manual-approved lubricant or sealant, then carry out the prescribed leak check. The appropriate test depends on the assembly; no pressure rating is specified on this page.

For comparison, a separate reference is listed as 16Y-16-00007. Similar product names do not show that the two numbers are interchangeable.

Questions buyers ask

Why was the part number cleaned?

The source field had an extra trailing space; the actual reference remains 154-15-41130.

Which machine does it fit?

The listing does not name a model. Verify by serial and catalogue position.

Are material and dimensions known?

They are not stated here. Request verified specifications if needed for selection.